Lessons Learned: Right Flight Wing Installed Incorrectly
An Ikarus C42 FB80 aircraft was taking off when the pilot discovered that the right flight wing was not installed correctly.
As the Ikarus C42 FB80 aircraft accelerated for takeoff at Yatesbury Field, Wiltshire, the pilot realized that the right flight wing was lifting about its two upper attachment points. He stopped on the runway and the aircraft sustained structural damage caused by the movement of the wing.
This would have been the first flight after the right flight wing was refitted following repair. Examination found that although the wing lower strut attachment pin was engaged through the aircraft attachment, the wing strut fitting had not been engaged correctly, and the pin did not pass through it. This meant that the inboard end of the lower strut was not attached to the aircraft fuselage. As the aircraft accelerated and the wing started to produce lift, it was able to rotate about the upper attachments.
The wing rigging procedure in the aircraft maintenance manual includes a final check to “lift the wing at the wing tip to ensure proper attachment . . . . ” The pilot said he was familiar with the installation and reported that the wing was fitted at the end of a long day. He believed it was correctly attached but did not recall attempting to lift the wingtip to ensure it was secure.
A British Microlight Aircraft Association (BMAA) Inspector had been asked to check a minor sail / fabric patch repair, which was duly done, but this did not include checking the rigging, as the wing was already installed on the airframe.
The AAIB (Air Accidents Investigation Branch) reported on a similar occurrence in 2013 where the wing of another Ikarus C42 lifted during the takeoff roll and the pilot stopped before the aircraft became airborne. If either aircraft had continued and become airborne, it is likely that a serious accident would have occurred.
Content/image source/credit: AAIB, “AAIB investigation to Ikarus C42 FB80, G-CGNI,” published January 8, 2026.
