Lessons Learned: Influx During Drilling
![drilling](/wp-content/uploads/2024/04/Screen-Shot-2024-04-05-at-4.49.27-PM-1.png)
Influx observed while drilling an offshore deepwater HPHT well in the 12 ¼” hole section using MPD.
While drilling offshore with a Drillship in the 12 ¼” hole section at 4174m MDRT with 1.63 sg SBM, observed a 7 bbl gain. Drilling operations were stopped, however circulation was continued to maintain BHP with MPD. The MPD mode was switched to ‘Flow Control’ Mode. Observed SBP increasing from 90 to 500 psi and with that, an additional influx. The total Influx volume exceeded the 10 bbl limit that could be handled via MPD (11 bbl gain detected).
The well was then Shut-in on the Upper Annular. Both the SICP / SIDP were recorded at 350 psi. Perform well kill with 1.71 sg kill weight mud while keeping the BHP constant using MPD in “P@D” mode.
This lesson sharing shows how important is to determine the best estimate of pore pressure during well planning and also, how to use the proper MPD modes while drilling and when taking a kick.
What happened?
Drilling 12 ¼” section @4174m MDRT with 1.63 sg SBM, using MPD (‘’Surface Back Pressure’’ mode, 90 psi), noticed active pit level increasing – 7 bbl gain.
Stop drilling, kept circulation to maintain BHP with MPD. Switch MPD to “Flow Control” Mode (maintaining a flow in vs. flow out constant).
Observed SBP increasing from 90 to 500 psi and additional influx. Influx volume exceeding defined 10bbl limit that could be handled via MPD (11 bbl gain detected).
What went wrong?
- Pore pressure > CC prognosis.
- Incorrect MPD mode selected: ‘’flow control’’ instead of ‘’SPP mode’’ (maintain de pumping pressure constant) / Procedures implementation.
- Confusion in the decision making process during the influx management.
- First MPD experience on the rig.
Corrective actions and recommendations
- Review MPD mode selection during well control situation.
- Recovery plan: hand over between conventional WC & MPD operations.
Content source/credit: IOGP, “Influx observed while drilling an offshore deepwater HPHT well in the 12 ¼” hole section using MPD,” IOGP (International Organization of Oil & Gas Producers) WCI Lesson Sharing 24-4.
Which of these public TapRooT® RCA courses best meets your immediate needs?
Click the links and learn more about each TapRooT® course. Or call us at 865-539-2139 to speak with an instructor.
- 2-Day Root Cause Analysis
- 5-Day TapRooT® Advanced Root Cause Analysis Team Leader Training
- 2-Day Equifactor® Equipment Troubleshooting
- Virtual TapRooT® Root Cause Analysis Courses
Did you know we can come to your workplace for an on-site TapRooT® Course?
Do you have several people to train? Please contact us or call us (865-539-2139) about reserving date(s) for on-site training for your team. A TapRooT® Implementation Advisor will be happy to provide you with a quote.